Skip to main content

Thread: 12.10 software update - broken packages

-

when trying perform software update following message :

following packages have unmet dependencies:

libgl1-mesa-dri:i386: depends: libgcc1 (>= 1:4.1.1) 1:4.7.2-2ubuntu1 installed

have switched off software sources apart canonical , community maintained sources.

have read few threads might relevant refer steam. have not installed steam.

can ?.

billio; hi !

try terminal:
code:
sudo apt-get install -f sudo apt-get update sudo apt-get dist-upgrade
try , resolve dependency issue "dist-upgrade' use it's smart mode so.
hope helps


Forum The Ubuntu Forum Community Ubuntu Official Flavours Support Installation & Upgrades [ubuntu] 12.10 software update - broken packages


Ubuntu

Comments

Post a Comment

Popular posts from this blog

Some mp4 files not displaying correctly (CS6)

-
Image
a week ago in premiere pro cs6 world. one day updated windows, next day few .mp4 video files opened in premiere pro, played fine well, except fact display has green (sometimes multicolour, solid green block) bars in lower third of screen. see screenshot below.   these same files open/display fine in after effects, photoshop , vlc- , quicktime players. i'd read fromyears ago windows updates causing this, removed 1 of therecent kb's no avail. i did install adobemediaencodertrial_64-6.0.3-mul-adobeupdate and dynamiclinkmediaserverretail-1.0.1-mul-adobeupdate and reverted quicktime 7.6 but nothing makes difference.   in end, formatted c:\, reinstalled windows 7 ultimate 64bit , downloaded/installed 260 updates , reinstalled cs6 (and aforementioned ame , dlms updates , qt7.6) it's still same problem.   also tried exporting (part of) 1 of these files, see if wasn't display problem: exported file same properties original has green bars.   what else can do?   thanks in advanc
Read more

Thread: Samba is not authenticating with LDAP

-
hello everyone. i've setup hp proliant server running ubuntu precise 64bit. have server running precise has openldap server running on it. i'm trying samba server authenticate ldap server users able log samba using ldap credentials. followed directions on site: http://raerek.blogspot.com/2012/05/s...sing-ldap.html http://raerek.blogspot.com/2012/05/s...g-ldap_28.html i'm using mac running mountain lion connected samba share when message: "check server name or ip address, , try again. if continue have problems, contact system administrator." when go /var/log/samba/log.workstation [2013/04/02 21:56:33.187358, 0] auth/check_samsec.c:491(check_sam_security) check_sam_security: make_server_info_sam() failed 'nt_status_unsuccessful' $ testparm load smb config files /etc/samba/smb.conf rlimit_max: increasing rlimit_max (1024) minimum windows limit (16384) processing section "[oh-fileshare]&qu
Read more